The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Text excerpt from page 8 (click to view)
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted in the two top corners. Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in figur. Then turn them through 45° (arrow (A) vertical) until they lock into place.
45°
PR60
A
Door reversal
Unplug the appliance before all operations. To reverse the door, proceed as follows: 1. Remove the ventilation grill (D). 2. Unscrew the bottom hinge (E). 3. Remove the door by releasing it from the top hinge pin (G). 4. Remove the pin then mount these on the opposite side. 5. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. 6. Replace the freezer door. 7. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge; 8. Screw down the bottom hinge (E) on the opposite side by using the screws previously removed. 9. Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side. 10.Re-assemble the ventilation grill (D). 11.Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.
PR185
G
G
E F
E
F
F
D
F
Warning:
After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
